Workshop Manual

4C–23

DRIVE SHAFT SYSTEM

Actuator

Check for damage, cracking or other abnormality.

Functional Check

412RY00041

412RY00009

Verify functionality by applying voltage (12V) to terminals

3 and 4 and set the tester to terminal 1 and 2 according to

the table bellow.

State Trminal 3 Trminal 4

Electric

circuit

between

terminal

1 & 2

Functio

A +12V Ground OK 2WD

B Ground +12V NONE 4WD

If there is an abnormality, replace the actuator as an

assembly.

NOTE: Be careful not to permit the entry of water or dust

into of the actuator.

Dimentional Check

Measure illustrated sizes 1, 2, and 3.

412RY00010

Limit

1=64.3 mm (2.53 in)

2=6.7 mm (0.26 in)

3=6.7 mm (0.26 in)

Reassembly

1.Install the new oil seal which has been immersed in

differential gear oil, by using an oil seal installer

J–41693 and grip J–8092.

412RW034