Workshop Manual

4C–24
DRIVE SHAFT SYSTEM
2. Install a new needle bearing into inner shaft by using a
Installer J–41694 and grip J–8092.
412RS051
3.Place a new snap ring(internal) in inner shaft.
Install a new inner shaft bearing into the inner shaft.
412RS044
4.Install snap ring(external).
NOTE: Be careful not to damage the inner shaft.
5.Clean the housing contact surface of the front axle
case and insert inner shaft assembly into the front
axle case.
NOTE: Be careful not to damage seal.
6.Install snap ring internal in the groove of front axle
case.
NOTE: Be sure to install the snap ring properly.
412RW017
7.Apply differential gear oil to clutch gear, then install
clutch gear.
8.Apply differential gear oil to sleeve, then install
sleeve.
9.Clean contact surface with the front axle and actuator
mounting surface. Apply liquid gasket to the contact
surface on the front axle case, then install in the
housing.
412RW023
10.Tighten bolts to specified torque.
Torque: 75N·m(55 lb ft)
11.Clean the actuator contact surface with the housing
then Install and tighten shift position switch to
specified torque.
Torque: 39N·m (29 lb ft)