Workshop Manual

4C–48
DRIVE SHAFT SYSTEM
Reassembly
1.Install wheel pin.
411RS005
B Place hub on a wood workbench or a block of wood
approx. 6” by 6” to protect the wheel stud ends and
threads.
B Install wheel stud, using a hammer.
NOTE: Be sure wheel stud is started squarely and seats
completely.
2.Install the hub unit bearing to the knuckle.
Tighten the bolts to the specified torque.
Hub unit bearing bolt
Torque: 103±10 N·m (10.5 ± 1 kg·m)
If there is rust on the bearing and knuckle contact
surfaces, use sandpaper to remove it before installation.
3.Install the ABS sensor connector.
4.Install the disc rotor.
5.Install the brake caliper to the bracket.
Refer to
Front disc caliper assembly in Section 5C of this
Manual.