Workshop Manual

4C–51
DRIVE SHAFT SYSTEM
Reassembly
1.Install the wheel pin.
B Place hub on a wood workbench or a block of wood
approx. 6” by 6” to protect the wheel stud ends and
threads.
B Install the wheel stud, using a hammer.
NOTE: Be sure wheel stud is started squarely and seats
completely.
411RS005
2.Install the ABS rotor sensor to the hub unit bearing.
Tighten the bolts to the specified torque.
ABS rotor sensor bolt
Torque: 18.7±5 N·m (1.9±0.5 kg·m)
3.Install the hub unit bearing to the knuckle. Tighten the
bolts to the specified torque.
Hub unit bearing bolt
Torque: 103±10 N·m (10.5±1 kg·m)
If there is rust on the bearing and knuckle contact
surfaces, use sandpaper to remove it before installation.
Take care not to push the front drive shaft and oil seal out
of position.
4.Hand tighten the front drive shaft nuts.
Use new nuts.
5.Install the disc rotor.
6.Install the brake caliper to the bracket.
Refer to
Front disc caliper assembly in Section 5C of this
Manual.
7.Tighten the front drive shaft nuts to the specified
torque.
Front drive shaft nut
Torque: 245±19.6 N·m (25±2 kg·m)
411R200005
8.Caulk the front drive shaft nuts.
The caulking must be free of cracks.
411R200006