Workshop Manual

4C–54
DRIVE SHAFT SYSTEM
Disassembly
NOTE: For the left side, follow the same steps as right
side.
1.Raise the hooked end of the band with a screwdriver
or equivalent.
412RS009
2.Remove band(1).
3.Pry off circlip (1) with a screwdriver or equivalent.
412RS010
4.Remove drive shaft joint assembly.
5.Remove the six balls (1) with a screwdriver or
equivalent.
412RS012
6.Using snap ring pliers, remove the snap ring (1)
fastening the ball retainer to the center shaft.
412RS013
7.Remove ball retainer, ball guide and bellows.