Workshop Manual

4D2–11
TRANSFER CASE (TOD)
2.Install the plate, bracket, connector bracket and
ground cable of the harness assembly, and tighten
the transfer cover retaining bolts (16 pieces) to
specified torque.
Torque: 31 N·m (23 lb ft)
261RY00035
261RY00037
3.Install the front and rear companion flange.
4.Install the oil seal and washer, and using the flange
holder J–8614–11, install the new end nut to the
specified torque.
Torque: 167 N·m (123 lb ft)
5.Securely stake the end nut at one spot.
NOTE: Be sure to confirm that there is no clack at the
staked portion of the end nut after staking.
266RY00003
266R200004