Workshop Manual

4D2–12
TRANSFER CASE (TOD)
6.Apply recommended liquid gasket (LOCTITE 598 or
its equivalent) to the transfer cover and shift motor
assembly fitting surface.
261R200003
7.Install the shift motor assembly to the transfer cover
assembly.
Torque: 10 N·m (87 lb in)
8.Install the 4H and 4L switch.
Torque: 24 N·m (17 lb ft)
9.Install the harness assembly and shift motor harness
connector to the connector bracket.
10.Install the front and rear speed sensors to the transfer
cover.
Torque: 5 N·m (43 lb in)
11.Connect the harness assembly connector to the
clutch solenoid coil harness connector and 4H and 4L
switch.
B Fix the harness with harness bracket.
261RY00009
12.Install the driven gear and speedometer sensor to the
transfer case.
Torque: 25 N·m (19 lb ft)
261RY00034
13.Remove the filler plug and fill the transfer case with
ATF DEXRON

–II or III.
14. Wind the sealing tape around the filler plug thread and
tighten the plug to the specified torque.
Torque: 25 N·m (19 lb ft)
261RY00026
15.Install the breather hose to the transfer case.