Workshop Manual

4D2–14
TRANSFER CASE (TOD)
2.Remove the coil assembly set nuts (3 pieces) and coil
assembly from the transfer cover.
261RW030
3.Using snap ring pliers, remove the snap ring from the
transfer cover.
261RW047
4.Strike the speed gear and tone wheel with a rod or
other appropriate tool from the rear side of the
transfer cover assembly, and remove the ball bearing,
speed gear and tone wheel.
NOTE: Use care to prevent damage to the speed gear
teeth.
261RY00012
5.Using the bearing remover J–42805 and slide
hammer J–2619–01, remove the ball bearing of the
front output shaft from the transfer cover.
261RY00027
Inspection and Repair
Refer to “Inspection and Repair (Transfer Case
Assembly)” in this section.