Workshop Manual

4D2–26
TRANSFER CASE (TOD)
8.Remove the snap ring before the ring gear.
261RW025
9.Using the ring gear remover J–42806 and a bench
press, remove the ring gear from the transfer case.
261R200005
NOTE: Removing ring gear needs a high-load press.
This means the transfer case may be damaged.
To remove and replace the ring gear, it is recommended
that the transfer case assembly should be replaced.
10.Remove the ball bearing of the front output shaft from
the transfer case.
261RY00021
Reassembly
Oil Seal Replacement
1.Remove the oil seal of the front output shaft and input
shaft from the transfer case.
2.Apply the circumference of the new oil seal and fill the
lip with grease (BESCO L2 or its equivalent).
3.Using the oil seal installer J–42807, install the front
output shaft oil seal to the transfer case.
266RY00013