Workshop Manual

5B–5
ANTI–LOCK BRAKE SYSTEM
Rear Wheel Speed Sensor
Removal
1.Disconnect harness connector (1).
2.Remove sensor fixing bolt (2) .
3.Remove speed sensor (3).
350R100004
Inspection and Repair
1.Check speed sensor pole piece for presence of
foreign materials; remove any dirt, etc.
2.Check the pole piece for damage, and replace speed
sensor if necessary.
3.Check speed sensor cable for short or open, and
replace with a new one if necessary. To check for
cable short or open, bend or stretch the cable while
checking for continuity.
4.Check the sensor ring for damage including tooth
chipping, and if damaged, replace the axle shaft
assembly. Refer to removal of the sensor ring in
Section
4A2 “Differential (Rear)”.
Installation
1.Install speed sensor (3).
2.Tighten the sensor fixing bolt (2) to the specified
torque.
Torque : 24 N·m (17 lb ft)
3.Connect harness connector (1).
350R100004