Workshop Manual

5C–27
POWER–ASSISTED BRAKE SYSTEM
4.Measure dimension (4).
Dimension (4) (Standard): –0.1–0.1 mm
(–0.0039–0.0039 in)
331RW002
5.If dimension (4) is out of the standard range, adjust
push rod using the Push Rod Support J–39241.
331RW003
6.Mount plate and seal assembly in vacuum booster
front shell. Then install the retainer.
7.Install vacuum booster fixing nut and tighten the
specified torque.
Torque: 15 N·m (11 lb ft)
8.Install yoke clevis.
9.Connect vacuum hose and make sure that the arrow
on the hose points in the direction of the engine.
10.Install master cylinder, refer to
Master Cylinder
Installation in this section.