Workshop Manual

5C–29
POWER–ASSISTED BRAKE SYSTEM
Inspection and Repair
Visual Check
Make necessary parts replacement if cuts, nicks,
excessive wear, or other abnormal conditions are found
through inspection. Check the following parts:
B Yoke clevis
B Valve body guard
B Silencer
B Filter plate and seal assembly
Installation
1.Install plate and seal assembly.
2.Install retainer.
3.Install 2 gaskets and spacer.
4.Install filter.
5.Install silencer.
6.Install valve body guard.
7.Install retainer.
8.Install lock nut and yoke clevis and tighten to the
specified torque.
Torque: 20 N·m (15 lb ft)
9.Install vacuum booster, refer to
Vacuum Booster in
this section.
10.Install master cylinder, refer to Master Cylinder in this
section and after installation, perform brake pedal
check and adjustment. Refer to Brake Pedal in this
section.
Vacuum Booster Overhaul
Vacuum Booster
The vacuum booster cannot be disassembled for repair.
Replace a defective vacuum booster with a new one.