Workshop Manual

5C–33
POWER–ASSISTED BRAKE SYSTEM
Removal
NOTE: If a squealing noise occurs from the front brake
while driving, check the pad wear indicator plate. If the
indicator plate contacts the rotor, the disc pad assembly
should be replaced.
B Draw out two–thirds of the brake fluid from the
reservoir.
B Raise the vehicle and support it with suitable safety
stands.
1.Remove wheel and tire assembly, refer to Wheels
and Tires System
in Section 3E.
2.Remove lock bolt (1).
302RW004
3.Rotate caliper assembly and support the caliper
assembly so that the brake hose is not stretched or
damaged.
4.Remove pad assembly with shim.
5.Remove Clip.
Installation
1.Install clip.
302RS005
2.Apply special grease (approximately 0.2 g) to both
contacting surfaces of the inner shims (2). Wipe off
extruded grease after installing. Install pad assembly
with shim.
302RW005
Legend
(2) Inner Shim
(3) Wear Indicator
(4) Inner Side