Workshop Manual

5C–37
POWER–ASSISTED BRAKE SYSTEM
Removal
1.Raise the vehicle and support with suitable safety
stands.
2.Concernig wheel and tire assembly, refer to Wheels
and Tires System in Section 3E.
3.Remove the bolt and gaskets, then disconnect the
flexible hose from the caliper and after disconnecting
the flexible hose (1), cap or tape the openings to
prevent entry of foreign material.
302RW009
4.Since the brake fluid flows out from the connecting
coupler, place a drain pan under the vehicle.
5.Remove guide bolt (2).
6.Remove lock bolt (3).
302RW010
7.Remove caliper assembly.
8.Remove support bracket with pad assembly and take
care not to damage the flexible brake hose when
removing the support bracket.
9.Remove pad assembly with shim and mark the lining
locations if they are to be reinstalled.
10.Remove clip.
Installation
1.Install clip.
302RS005
2.Apply special grease (approximately 0.2 g) to both
contacting surfaces of the inner shims (4). Wipe off
extruded grease after installing. Install pad assembly
with shim.
302RW011
Legend
(4) Inner Shim
(5) Wear Indicator
(6) Inner Side