Workshop Manual

5C–79
POWER–ASSISTED BRAKE SYSTEM
7.Tighten the steering column fixing nut (9) (Cross
Beam) to the specified torque.
Torque: 17 N·m (12 lb ft)
8.Apply grease to the entire circumference of the Push
rod pin (7).
9.Install push rod pin (7).
10.Install snap pin (4).
11.Connect the anti-theft control module connector.
Refer to
Body and Accessories section.
12.Connect the stop light switch connector (3).
13.Install driver knee bolster (10) and lower cover (8).
14.Install the engine hood opening lever.
15.Connect the yellow 3 way SRS connector located
under the steering column.
16.Connect the battery “–” terminal cable.
Stoplight Switch
Parts Location
310RW008
Legend
(1) Connector
(2) Switch
(3) Lock Nut
Removal
1.Disconnect connector (1)
2.Remove lock nut (3).
3.Remove switch (2).
Installation
1.Adjust the stop light switch to the specified clearance
(between switch housing and brake pedal) by rotating
the switch housing.
Clearance : 0-0.2 mm (0-0.08 in)
NOTE: Do not attempt to force the push rod into position
during the stop light switch installation and adjustment
procedure.
310RY00005
2.Connect connector (1).
3.Install lock nut (3).