Workshop Manual

6A–20
ENGINE MECHANICAL (6VE1 3.5L)
Installation
1.Install cylinder head cover.
B Clean the sealing surface of cylinder head and
cylinder head cover to remove oil and sealing
materials completely.
B Apply sealant (TB-1207B or equivalent) of bead
diameter 2-3 mm at eight place of arched area of
camshaft bearing cap on front and rear sides.
B The cylinder head cover must be installed with in 5
minutes after sealant application to prevent
hardening of sealant.
B Tighten bolts to the specified torque.
Torque : 9 N·m (78 lb in)
010RW008
2.Install fuel injection harness bracket and tighten bolt
to the specified torque.
Torque : 9 N·m (78 lb in)
3.Connect ignition coil connector and ignition coil, then
tighten bolt to the specified torque.
Torque : 4 N·m (35 lb in)
060RY022
Legend
(1) Ignition Coil Connector
(2) Bolt
(3) Ignition Coil Assembly
CAUTION: Ignition coil assembly #6 is different
from ignition coil assembly from #1 to #5. Ignition
coil assembly #6 is short type. So, note it when
installing ignition coil assembly of #6.
060RY00002
Legend
(1) Long Type Ignition Coil Assemblies (# 1 ∼ # 5)
(2) Short Type Ignition Coil Assembly (# 6)
4.Connect ground cable and tighten bolts to the
specified torque.
Torque : 9 N·m (78 lb in)
5.Install positive crankcase ventilation hose.
6.Install engine cover mating with the dowels.