Workshop Manual

6A–33
ENGINE MECHANICAL (6VE1 3.5L)
Installation
1.Install camshaft drive gear assembly and tighten
three bolts to the specified torque.
Torque : 10 N·m (87 lb in)
2.Tighten bolt for camshaft drive gear assembly pulley
to the specified torque.
Torque : 98 N·m (72 lb ft)
3.Tighten sub gear setting bolt.
1. Use J-42686 to turn sub gear to right direction
until it aligns with the M5 bolt hole between
camshaft driven gear and sub gear.
2. Tighten the M5 bolt to a suitable torque to prevent
the sub gear from moving.
014RW041
4.Install camshaft assembly and camshaft bearing
caps, tighten twenty bolts on one side bank to the
specified torque.
1. Apply engine oil to camshaft journal and bearing
surface of camshaft bearing caps.
2. Align timing mark on intake camshaft (one dot for
right bank, two dot for left bank) and exhaust
camshaft (one dots for right bank, two dots for left
bank) to timing mark on camshaft drive gear (one
dot).
014RW020
Legend
(1) Intake Camshaft Timing Gear for Right Bank
(2) Intake Camshaft Timing Gear for Left Bank
(3) Exhaust Camshaft Timing Gear
(4) Discrimination Mark
(LI: Left bank intake, RI: Right bank intake)
(LE: Left bank exhaust, RE: Right bank
exhaust)
014RW023
Legend
(1) Right Bank Camshaft Drive Gear
(2) Left Bank Camshaft Drive Gear
(3) Timing Mark on Drive Gear
(4) Dowel Pin