Workshop Manual

6A–48
ENGINE MECHANICAL (6VE1 3.5L)
9.Install air conditioner compressor to engine and
tighten to the specified torque.
Torque :
M8 bolts : 22 N·m (16 lb ft)
M10 bolts : 43 N·m (32 lb ft)
10.Install power steering pump, tighten fixing bolt to the
specified torque.
Torque :
M8 bolts : 22N·m (16 lb ft)
M10 bolts : 46 N·m (34 lb ft)
11.Move drive belt tensioner to loose side using wrench,
then install drive belt to normal position.
850RW001
Legend
(1) Crankshaft Pulley
(2) Cooling Fan Pulley
(3) Tensioner
(4) Generator
(5) Air Conditioner Compressor
(6) Power Steering Oil Pump
(7) Idle Pulley
(8) Drive Belt
12.Install upper fan shroud.
13.Reconnect radiator upper and lower hoses.
14.Reconnect coolant reserve tank hose to radiator.
15.Reconnect generator harness connector.
16.Reconnect starter harness connector.
17.Reconnect bonding cable terminal on left bank
18. Reconnect bonding cable terminal on the back of right
dash panel.
19.Reconnect ground cable between engine and
chassis.
20.Reconnect harness connector to transmission and
install transmission harness bracket on engine left
side.
21.Reconnect three engine harness connectors.
22.Reconnect vacuum booster hose.
23.Reconnect canister vacuum hose.
24.Install air cleaner assembly.
25.Reconnect air duct.
26.Reconnect throttle position sensor harness
connector.
025RY001
Legend
(1) Throttle Position Sensor Connector
(2) Throttle Valve Assembly
27.Reconnect manifold absolute pressure sensor
harness connectors.
28.Reconnect ion sensing module connectors as shown
in the illustration.
060RY00111
Legend
(1) Green Connector
(2) Blue Connector
(3) Identification Mark (6VE1 Engine Only)
29.Install engine hood to the original position.
B Refer to installation procedure for Body section in
this manual.