Workshop Manual

6A–84
ENGINE MECHANICAL (6VE1 3.5L)
012RS006
Reassembly
1.Install cylinder block.
2.Install crankshaft.
B Install the main bearings to the cylinder block and
the main bearing caps.
B Be sure that they are positioned correctly.
B Apply new engine oil to the upper and lower main
bearing faces.
NOTE: Do not apply engine oil to the bearing back faces.
015RS012
Legend
(1) Number 1 and 4 main bearing upper and lower.
(2) Number 2 and 3 main bearing upper.
(3) Number 2 and 3 main bearing lower.
B Carefully mount the crankshaft.
B Apply engine oil to the thrust washer.
B Assemble the thrust washer to the No. 3 bearing
journal. The oil grooves must face the crankshaft.
015RS013
3.Install rear oil seal retainer.
B Remove oil on cylinder block and retainer fitting
surface.
B Apply sealant (TB1207B or equivalent) to retainer
fitting surface as shown in illustration.
B The oil seal retainer must be installed within 5
minutes after sealant application to prevent
premature hardening of sealant.
015RW002
Legend
(1) Around Bolt Holes
(2) Around Dowel Pin