Workshop Manual

6D3–21
STARTING AND CHARGING SYSTEM (6VE1 3.5L)
7.Remove bolts which secure stator terminal to rectifier
terminal, and remove stator.
066RS030
8.Remove Bolts which secure regulator, rectifier and
brush-holder, and separate these parts.
NOTE: Do not apply a shock or load to regulator, rectifier
and brush holder.
066RW025
Inspection and Repair
Repair or replace necessary parts if extreme wear or
damage is found during inspection.
Rotor Assembly
1.Check the face of the slip rings for contamination and
roughness. If found to be scored, dress with a fine
sandpaper (#500 –600). If found to be contaminated,
clean with a cloth saturated with alcohol.
2.Measure the outside diameter of the slip rings.
Standard: 27mm (1.06in)
Limit: 26mm (1.02in)
066RS032
3.Check resistance between slip rings, and replace if
there is no continuity.
Standard: 3.75W or less
066RS033