Workshop Manual

5–10 ENGINE ASSEMBLY III
Important Operations
1. Oil Jet
Install the oil jets taking care not to damage the oil
jet nozzles.
N·m (kgf·m/lb.ft)
2. Crankshaft Bearing (Upper Half)
5. Crankshaft Bearing (Lower Half) and Crankshaft
Bearing Cap
The Crankshaft Bearing Configuration
Take care not to misinstall the bearing halves.
With oil hole
and groove (upper)
Fit correctly
No oil groove and hole
(lower)
4. Thrust Bearing
Install the thrust bearings with the oil groove side
facing the crankshaft sliding face.
Oil groove side
5. Crankshaft Bearing Cap
1) Lubricate the bearing cap bolts with engine oil.
2) Install the bearing caps to the crankshaft.
The arrow mark must be pointing to the front of
the engine.
3) Tighten the bearing cap bolts to the specified
torque a little at a time in the numerical order
shown in the illustration.
Front
Arrow mark
(Position No. punched)
Oil Jet Torque 16–25 (1.6–2.6/12–19)
With Oil Groove Without Oil Groove
Bearing
4B All Upper Halves —
Upper Half
6B All Upper Halves —
All Lower Halves
Center Bearing
Bearing
4B Except Center
Only
Lower Half
Bearing
6B — All Lower Halves