Workshop Manual

ENGINE ASSEMBLY III 5–13
13. Flywheel Housing
1) Apply a sealant to the shaded area of the illus-
tration.
2) Install the flywheel housing.
Tighten the flywheel housing bolts to the speci-
fied torque.
N·m (kgf·m/lb.ft)
15. Oil Pan
1) Apply sealant to the area indicated by the
arrows in the illustration.
2) Install the oil pan gasket
3) Install the oil pan.
Tighten the oil pan bolts to the specified torque.
N·m (kgf·m/lb.ft)
16. Oil Cooler
1) Apply sealant to the oil cooler gasket.
2) Install the oil cooler gasket to the oil cooler body
case.
3) Install the oil cooler.
Tighten the oil cooler bolts to the specified
torque.
Start from the middle and work out to either
side.
Refer to the illustration
N·m (kgf·m/lb.ft)
Oil Pan Bolt Torque 21–30 (2.1–3.1/15–22)
Flywheel Housing
Outer Bolt 147–167(15.0–17.0/108–123)
Bolt Torque
Inner Bolt 21–30 (2.1–3.1/15–22)
Oil Cooler Torque
4B 16–25 (1.6–2.6/12–19)
6B 14–24 (1.4–2.4/10–17)
11.6±0.3mm (0.457±0.012in)
14. Rear Oil Seal (Axial Type)
1) Tighten the adapter to the crankshaft rear and
section with 2 bolts.
2) Insert the oil seal into the peripheral section of
adapter.
3) Insert the sleeve into the adapter section, and 1)
tighten it with a bolt until the adapter section
hits the sleeve.
4) Remove the adapter and the sleeve.
5) With the seal pressed in, check the dimension of
the oil seal section.
Standard Dimension = 11.6 ± 0.3 mm
(0.457 ± 0.012 in)
Oil Seal Installer:
4BG1 5-8840-2357-0
6BG1 5-8840-9025-0