User's Manual

• When the battery is drained, ⑤ on the eXo will blink every 2 seconds.
• We recommend fully charging the battery for 3 hours prior to initial use.
• When the charging cable is connected, ② will illuminate red while charging and Switch
to green when charging is complete.
• Charging is possible even when the device is powered off.
VI. Paring the eXo with a PC that Already has a Bluetooth®
Transmitter:
1. Click on the Bluetooth® icon in the Control Panel window.
2. Click on the DEVICE Tab. If the eXo is displayed, registration has already been
completed and no further steps are necessary. If the eXo is not listed, click on Add….
3. Ensure the eXo is in paring mode by follow the steps above entitled Paring
4. Next, check the box for “My device is set up and ready to be found.”
and click Next.
Page5
IV. Paring :
• Pairing varies depending on the type of Bluetooth® connection used. Ensure first that
your Bluetooth® computer supports the HID function before paring.
• For computers that are already paired with the eXo, the paring process is not necessary
after restarting your computer. Reconnection is automatically made when the eXo is
powered and the computer is ready to receive a Bluetooth® signal. Also, when the eXo is
powered off, is out of range, or has radio interference, the device can loose its connection
to the PC. Reconnection is made by turning the eXo OFF then back ON.
• In order to pair your device, turn the eXo OFF then back ON and then press both ① ③
simultaneously for 5 seconds . To indicate the device is in pairing mode, the green and
red LEDs will flash.
• If you are not able to enter pairing mode, repeat this procedure.
V. Charging:
In order to charge your eXo, connect it to the charging cable via the port on the
top and connect the cable to any available USB port on your computer.
USB
Page6
①
③