User's Manual

• Li-ion battery (3.7 VDC, 1200 mAh) • VCR on-work display
• Internal & external microphone
PIN DESCRIPTION OF THE BASE OUTPUT PORT
Connector wire
Pin #1 : MIC trigger (blue)
Pin #2 : Panic Trigger (black)
Pin #3 : Inside car mic trigger(yellow)
Pin #4 : GND(orange)
Pin #5 : 12V VDC_IN (red)
Pin #6 : VIDEO_ON (brown)
Audio jack
Pin #1 AUDIO_GND
Pin #2 AUDIO_OUT (output from the port)
Pin #3 car mic out
CHARGING THE BATTERY (FULL CHARGE)
1. Once the BASE has power connection, place the transmitter in its cradle on the BASE.
2. Leave the transmitter on the cradle for at least 4 hours for a full charge.
3. Charge LED stays red during charging and turns green after full charge.
PREPARING FOR INITIAL USE
1. Ensure that the fully charged before initial use.
2. Check line and power connections to the BASE.
3. Select the ON position of power switch
4. Push the TALK button of the transmitter to check the operation.
OPERATION
1. Supply 12 VDC power into the BASE using the Car Battery.
2. 1) Separate the transmitter from the BASE and turn on the transmitter.
2) When In-Use LED blinks for a few seconds and stops blinking, communication channel between
Base and Transmitter has been set up. When In-Use LED keeps blinking, the communication
channel between Base and Transmitter does not match.