User Manual

10
FM RADIO OPERATION
CD OPERATION
1. Press the FUNCTION button on the unit or the FUNC button on the remote
control to switch to FM mode, the FM frequency will appear on the display.
3. Press TUN- or TUN+ button to manually adjust the frequency.
found, and it will play automatically.
2. Press and hold TUN- or TUN+ to search automatically until a station is
4. Press the REPEAT button on the remote control to switch between stereo
and mono.
NOTE: For best reception, extend the antenna on the back of the unit.
Automatic Scanning and Programming
Manual Programming
- Press and hold the SCAN button on the unit or remote control to scan and
save the available stations automatically, it can save 20 stations in total.
- After scanning is finished, it will play the first programmed station.
- Press the or button to select and play the desired programmed station.
- Press TUN- or TUN+ button to set and play the desired station
- Press the PROG button on remote control, "PXX" will appear on display, here
"XX" stands for "01-20".
- Press the or button to select the desired storing location.
- Press the PROG button on the remote control to confirm storing. Note: The
station that was stored before will be replaced.
- Repeat the above steps to store more programmed stations.
1. Press the FUNCTION button on the unit or on the remote control
to switch to CD mode. If there is no disc in disc compartment, "diSC" will appear
on display.
3. The unit will play the CD automatically within a few seconds.
Operation while playing:
2. Press the button to open the disc compartment, place a CD disc with label
side facing up, then press the button again to close.
- Press the or button to skip to the previous or next track.
- Press the button to pause, the track number will blink on the display,
press the button again to resume.
- Press the button to stop playing, press the button to play the first track.