User Manual

ManualsBrandsit.innovative technology ManualsCompact Radios & StereosInnovative Technology Victrola Bluetooth CD Stereo System, Silver

REMOTE CONTROL BATTERY INSTALLATION

Follow these precautions when using a battery in this device:

1. Use only the size and type of battery specified.

2. Be sure to follow the correct polarity when installing the battery as indicated in the battery

ompartment, a reserved battery may cause damage to

the device.

3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc)

or old batteries with fresh ones.

4. If the batteries in the device are consumed or the device is not to be used for

a long

period of time,

remove the batteries to prevent damage or injury from

possible

leakage.

5. Do not try to recharge the battery as it is not intended to be recharged; it can

overheat

and rupture.

(Follow the battery manufacturer’s instructions.)

6. The batteries shall not be e

xpo

sed to excessive heat such as sunshine or fire.

7. Clean the battery contacts and also those of the device prior to battery

installation.

8. The remote control is supplied with a coin/button

cell battery. If the coin button cell battery is

swallowed, it can cause severe internal burns in

just 2 hours and can lead to death. Keep new

and used batteries away from children. If the

Battery compartment does not close securely,

stop using the product and keep it away from

children. If you think batteries might have been

swallowed or placed any part of the body, seek

immediate medical attention.

CR2025

CAUTION

●Danger of explosion if the battery is incorrectly replaced.

●Replace only with the same or equivalent type.

Fig.2

Fig.3

Fig.4

Remote Control Operation Range

●

● When direct sunlight, an incandescent lamp, fluorescent lamp or any other strong light

shines on the REMOTE SENSOR of the unit, the operation of the

remote may be

unstable.

When there is an obstacle between the transmitter and the unit, the unit may not operate.

Remove and discard the insulation film as shown on Fig. 1.

RELEASE

PUSH

OPEN

R2025

Fig.1

1. Push and slide out the battery holder as shown on Fig.2.

2. Replace the battery with a new CR2025 button cell as the polarity

marking facing upward as shown on Fig.3.

3. Close the battery door as shown on Fig.4.

FIRST TIME USE

BUTTON CELL REPLACEMENT

BATTERY PRECAUTIONS