Installation Guide

3/5
Remove mounting plate from back of towel ring.
a. Use the provided allen wrench to loosen set screw on
bottom of the towel ring to remove the mounting plate.
Use a soft cloth or sponge with water, then dry with a soft cloth. Avoid detergents, abrasive cleaners, solvents, steel and bronze wool.
Visit https://youtu.be/oyTQ2F-oOjI for an easy to follow installation video.
Contact [e-mail] for questions or further information
Drill holes in using ¼” drillbit.
a. Mounting into wood studs is recommended;
b. If mounting into tile use a masonry stone drillbit.
Insert provided anchors if mounting into drywall. Anchors
not necessary if mounting into wood studs.
a. Optional: Use a dab of caulking on the wall anchors for
a better hold;
b. If drilling into tile use masonry wall anchors (not included).
Install the mounting plate with the provided screws.
a. The ange side should be facing out;
b. Optional: Use a dab of caulking on the back of each
mounting disc for a better hold.
Place item over the mounting plates with the set screw
on the bottom.
Use the provided allen wrench to adjust the set screw to
lock into place with the mounting bracket.
4
5 6
7 8
Care Instructions
Place mounting plate on the wall and mark position of
the holes in the mounting plate.
3
Installation Instructions Towel Ring
1
Level and mark position of the towel ring on the wall.
a. If mounting into ceramic or tile, place masking tape on the
mounting areas before marking the location to prevent the
drill from slipping and damaging the tile.
2