Installation Guide

1/2
Installation & Care Guide
By DGB Enterprises LLC
www.italiabath.com
[e-mail]
Italia Towel Bar
Phillips Screwdriver
1 x Allen Wrench
4 x Plastic Wall Anchors
4 x Mounting Screws
2 x Mounting Bracket Plate
(Located pre-installed in item. Must
be removed prior to installation).
2 x Set Screws
(Located pre-installed in item. Must be loosened
to remove the mounting plate prior to installation).
Tools required:
Hardware Included:
Image featured: VE2701
Power Drill ¼” Drillbit
Tile / Masonry Stone Drillbit
if Drilling Into Tile or Stone
(Masonry wall anchors not included)
Hammer
Level Tape Measure Pencil
Remove mounting plate from back of towel bar.
a. Use the provided allen wrench to loosen set screw on
bottom of the towel bar to remove the mounting plate.
Level and mark position of the towel bar on the wall.
a. If mounting into ceramic or tile, place masking tape on the
mounting areas before marking the location to prevent the
drill from slipping and damaging the tile.
1 2
Tools & Hardware
Installation Instructions