Data Sheet

RB-Ite-25

Electronic Brick Magnetic Sensor/Switch

Overview

This is a Electronic Brick interface compatible Magnetic switch module. It is based on encapsulated dry

reed switch CT10. CT10 is single-pole, single throw (SPST) type, having normally open ruthenium

contacts. The sensor is a double-ended type and may be actuated with an electromagnet, a permanent

magnet or a combination of both. The magnetic switch is a wonder tool for designers who would like to

turn a circuit on and off based on proximity.

Connect the + pin to 5v and - pin to GND, S pin will output the digital value which will tell you if there is

some magnetic nearby. It can be used with Iteaduino directly with a 3PIN cable.

Features

 Electronic Brick interface

 Minimum external parts

 10W rating

 Rugged encapsulation

Programming

PAGE 1
RB-Ite-25 Electronic Brick Magnetic Sensor/Switch Overview This is a Electronic Brick interface compatible Magnetic switch module. It is based on encapsulated dry reed switch CT10. CT10 is single-pole, single throw (SPST) type, having normally open ruthenium contacts. The sensor is a double-ended type and may be actuated with an electromagnet, a permanent magnet or a combination of both. The magnetic switch is a wonder tool for designers who would like to turn a circuit on and off based on proximity.
PAGE 2
Connect the module with Iteaduino using D9. The program below shows how to use the Magnetic switch to control the led. When you put a magnet that has enough magnetic power close to the module, the switch is closed .Then the S pin out put a high voltage. You can use this to control the led. Electronic Brick Yes! manufacturer can build electronics projects just as easy as piling bricks. Arduino and community have made the programming much easier than ever before.