Installation Guide

Iteaduino Nano Driver Installation Manual iteadstudio.com 2

, July, 2013

Tech Support: support@iteadstudio.com

Iteaduino Nano Driver Installation Manual

As Iteaduino Nano utilizes USB to serial port chip of CP2102 series instead of FT232RL on Arduino Nano, we cannot use

driver program in Driver file in Arduino IDE for drive installation.

http://www.silabs.com/products/interface/usbtouart/Pages/usb-to-uart-bridge.aspx

You can download CO2012 driver for various platforms in the TOOL page here, including MAC version, Linux version and

Windows version.

Let’s take Windows version for an example to show you the installation steps:

First, after connecting to Iteaduino Nano, USB searched for driver and installation failed. Then open hardware device

manager in Windows system, and we can find device‘CP2102 USB to UART Bridge Controller’ with no driver installed.

Select the device, open right-click menu and choose ‘Update driver software’ option:

PAGE 1
Tech Support: support@iteadstudio.com Iteaduino Nano Driver Installation Manual As Iteaduino Nano utilizes USB to serial port chip of CP2102 series instead of FT232RL on Arduino Nano, we cannot use driver program in Driver file in Arduino IDE for drive installation. http://www.silabs.com/products/interface/usbtouart/Pages/usb-to-uart-bridge.aspx You can download CO2012 driver for various platforms in the TOOL page here, including MAC version, Linux version and Windows version.
PAGE 2
Tech Support: support@iteadstudio.com In the pop-up window, choose ‘Browse my computer for driver software’: Select route of downloaded driver file location, tick ‘Include subfolders’, then click ‘next’: Then the system will install the driver program automatically – during the process, a prompt window may be popped up asking whether to trust the driver source or not, choose yes. After driver is installed, disconnect Iteaduino Nano.