User's Manual

2 3 4 5 6
1201784
User’s Guide
Bluetooth
®
Portable Music Receiver
We hope you enjoy your Bluetooth Portable Music Receiver
from RadioShack. This receiver allows you to wirelessly
connect Bluetooth devices to non-Bluetooth speakers, so
that you can play and listen to your favourite music wirelessly.
Please read this user's guide before using your receiver.
Package Contents
• Bluetooth Portable Music Receiver
• USB charging cable
• User’s Guide
Specifications
Battery Type...............................Built-in 160 mAh lithium polymer
Bluetooth Protocol...........................................................Version 4.2
Support Prole............................................................................A2DP
Operating Distance.........................................................33 ft. (10 m)
Battery Charge Time..............................................Approx. 2 Hours
Operating Time............................................................Up to 5 Hours
Charging Port......................................................................Micro USB
Charging Cable Length..................................................3 ft. (0.91m)
Specications are subject to change and improvement without
notice. Actual product may vary from the images found in this
document.
Complies with the European Union’s
“Restriction of Hazardous Substances
Directive,” which protects the
environment by restricting specic
hazardous materials and products.
11A16
1201784
Printed
in China
© 2016 General Wireless Operations Inc.
All rights reserved. RadioShack is a registered
trademark used by General Wireless
Operations Inc. dba RadioShack.
radioshack.com
The Bluetooth® word mark and logos are owned by Bluetooth
SIG, Inc. and any use of such marks by General Wireless
Operations Inc. is under license.
Charge
You can charge the receiver when it is idle or in use.
1. Use the USB charging cable to connect the receiver to a
USB power source. While charging the receiver, the red
LED lights, and turns o when charging is complete.
A full charge takes about 2 hours, and provides up to 5
hours play time.
2. After charging, unplug the charging cable. Do not
attempt to overcharge.
Note:
• If the receiver's red LED ashes every 8 seconds, the
receiver battery is weak. Follow steps 1-2 to charge the
receiver.
• Use only the supplied cable, or one with the same
specication to charge. Use of any other cables may
damage the receiver.
Set up the Receiver
1. Connect the 1/8" (3.5 mm) stereo output jack to the
audio input port on your stereo system. Refer to your
stereo system's user manual for the location of the
audio input port.
Using the Receiver
To... Press the button...
Play/ Pause × 1
Nex t Track × 2
Changing Bluetooth Devices
To pair a new device, you must disconnect your device's
Bluetooth connection with the receiver rst. The LEDs on
the receiver then ashes blue and red steadily. Follow the
instructions in "Pairing" to connect to a new device.
FCC Information
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
If you cannot eliminate the interference, the FCC requires that you
stop using your equipment. Changes or modications not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
Connect to
a USB power
source to
charge
2. To turn on the receiver, press and hold the receiver
button for 3 seconds until the blue LED ashes 3 times.
3. The LEDs on the receiver then ashes red and blue
rapidly as the receiver searches for Bluetooth-enabled
devices.
Pairing
1. Turn on the Bluetooth function on your device.
2. Locate the Bluetooth devices list, and select
"RadioShack 1201784" from the list.
3. Once paired successfully, the LED lights blue every 8
seconds.
4. To turn o the receiver, press the receiver button until
the red LED ashes 3 times.
Note:
• The receiver automatically pairs with the previously paired
device when the Bluetooth function of the device and the
receiver are both turned on.
• The receiver can pair and memorize 8 paired devices. If
you wish to pair with more than 8 devices, the least used
device is deleted from the memory and replaced.
• If your device is out of connection range and disconnects,
move back within 10 minutes to reconnect automatically.
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Limited Warranty
Go to www.radioshack.com/help for details.
RadioShack Customer Relations
300 RadioShack Circle, Fort Worth, TX 76102
1/8" (3.5 mm)
stereo output jack
USB Charging Port
LEDs
Button
AUDIO I N
1201784_UG_EN_A_101716.indd All Pages 11/22/2016 3:45:54 PM