User Manual

Remove the radio from the carton and remove all packing material from the radio.
Save the packing material,if possible,in case the radio ever needs to be serviced
or transported.The original carton and packing material is the only safe way to
pack your radio to protect it from damage in transit.
Remove any descriptive labels or stickers on the front or top of the cabinet.
Do not remove any labels or stickers from the back or bottom of the cabinet.
Note the serial number on the bottom of your radio and write this number in the
space provided on the Warranty page of this manual.
Place your radio on a level surface such as a table,desk or shelf,convenient to
an AC outlet,out of direct sunlight,and away from sources of excess heat,dirt,
dust,moisture, humidity, or vibration.
Unwind the Line cord connecting the AC adapter and extend it to its full length.
The FM antenna is built in to this cord.It must be fully extended to provide the best
FM reception.
Unpacking And Set Up
Protect Your Furniture
This model is equipped with non-skid rubber 'feet' to prevent the product from
moving when you operate the controls.These'feet'are made from non-migrating
rubber material specially formulated to avoid leaving any marks or stains on your
furniture. However certain types of oil based furniture polishes, wood preservati-
ves, or cleaning sprays may cause the rubber 'feet' to soften,and leave marks or a
rubber residue on the furniture.To prevent any damage to your furniture we
strongly recommend that you purchase small self-adhesive felt pads, available at
hardware stores and home improvement centers everywhere, and apply these
pads to the bottom of the rubber'feet'before you place the product on fine wooden
furniture.
Power Source
This radio is designed to operate on normal 120V 60Hz AC power only. Do not
attempt to operate the radio on any other power source. You could cause damage
to the radio that is not covered by your warranty. This radio should be connected
to an AC outlet that is always'live'. Do not connect it to an outlet that is controlled
by a wall switch. When the power to the radio is interrupted, the built in lithium
battery takes over to maintain the time and alarm settings. To maximize the life of
the lithium battery keep the radio connected to a 'live' AC outlet at all times.
• Operate controls and switches as
described in the manual.
• Before turning on the power,
make certain that the AC adapter
is properly installed.
• When moving the set, be sure to
first disconnect the AC adapter.
• Avoid installing this unit in places
exposed to direct sunlight or close to
heat radiating appliances such as:
electric heaters, on top of other stereo
equipment that radiates theat, places
lacking ventilation, dusty areas, places
subject to constant vibration and/or
humid or moist areas.
• CKS507 clock radio x 1
• AC Power Adapter 110V-240AC 50/60Hz,DC 5V x1
• User Manual x 1
Preparation For Use
Important Notes
What Inside