Use and Care Manual

LED Display Screen
Scheduled Cleaning Mode
Press TIMER " " button and SPOT " " button on the remote controller. The " " icon
on the cleaner panel will light up and the cleaner enters into the current week day hour/
minute setting and schedule week day, hour/minute setting (see page 11 for the schedule
setting of the remote controller).
LED Display Screen
Battery Installation & Maintenance
To install the battery, use a screwdriver to loosen the four screws on the half-moon shaped bottom shell,
and then remove the battery installation cover (see Fig. 1).
When installing the battery, connect the snap joints of the two terminals (see Fig. 2).
When not in use, place the cleaner into recharging status, which will maintain optimal battery
performance.
If the cleaner is left unused for an extended time, recharge the cleaner once a month to maintain optimal
battery performance.
The battery can only be replaced with a battery from the original manufacturer. Use of batteries from
other sources may damage the cleaner and will void the warranty.
Before cleaning, remove any small items or obstacles in the room, especially power
cords and other easy entanglements. When the battery power runs low during
cleaning, the cleaner will: 1) stop cleaning 2) produce five beeps 3) light up the recharging
light on the LED display screen 4) automatically return to the docking station.
Auto Cleaning Mode
Press this button and the cleaner will begin automatic cleaning mode. When the battery power
runs low, the cleaner will automatically return to the auto charging dock station. In the course of
cleaning, touch this button again and the cleaner will stop.
Attention
Attention
Attention: Before charging, make sure to turn the power switch of the cleaner to ON!
07
08
1. It is recommended to clean the suction inlet and dust sensor each time you empty the
dustbin.
2. When the cleaner is at work it follows a default settings path, but when it detects any
dust it will automatically switch to focused spiral cleaning.
3. To maximize wet mopping effectiveness (optional accessory) fill the water tank to
maximum capacity before beginning.
Push
to start only after you hear the voice alert "please select mode."
1.
2.
3.
4.
5.
Fig. 1 Fig. 2
Screwdriver
Snap
joint
Dustbin Full
The" "icon will light up to indicate that the suction inlet is blocked or the dust bin is full, or
the garbage sensors is covered with dust.
FULL GO Mode
When the cleaner is at stand by status, press the "      " on the remote controller and the cleaner
will enter the FULL GO mode. (Definition of FULL GO: When choosing this function the cleaner
will automatically clean one more time after it is fully charged again.)
Wet Mopping Mode (optional accessory)
First, install the small dustbin with the Intelligent Water Tank (refer to page 16 for the installation
method). The cleaner will automatically begin the water tank mopping mode. Press the " "
button to start auto cleaning and mopping and the " " icon will light up or blink. When
the water tank runs out of water, this icon will turn off, error code E012 will display, and the voice alert
"inject water, please" will play. If you want to continue this function during cleaning, take the water
tank out and refill it. Water emittance rate is configured in Settings (see page 11 for details).