Use and Care Manual
Installation & removal and
cleaning of the dust bin
13 14
1.Installation & removal of the dust bin of the cleaner
01. Press “PUSH” on the panel to pop out the dust cover (Fig. 1).
02. Take out the dust bin (Fig. 2).
2.Cleaning of the dust bin
01. Open the upper cover of the dust bin, pour out the dirt and other junk (Figs. 3,4, and 5).
02. The dust bin and the filter screen can be rinsed with water (Fig. 6).
Fig.3 Fig.4 Fig.5
Fig.2
Attention
Aft
er
rinsing,
dry the dust bin, filter and HEPA before replacing
them (with cool air from an electric hair dryer).
Please strictly follow the instructions when removing and
installing the dust bin.
1.
2.
Installation & removal and cleaning of
the main brush assembly
1. Removal of the roller brush assembly:
As shown in Fig. 1, pick the U shaped clip each side of the sweeping bracket simultaneously with
both index fingers to remove sweeping bracket.
As shown in Fig. 2, pull up the left end of the roller brush with a hand to take out .
As shown in Fig. 3, clean the hair off the brush, or wash it with water (do not replace it until it
becomes dry after washing).
As shown in Fig. 4, an enlarged view of the left part, remove the brush tube retainer on the left of
the roller brush, clean the hair off the retainer.
As shown in Fig.5, an enlarged view of the upper left part, remove the brush tube retainer on the
left of the roller brush, pull out the special brush strip of ONE COVER ALL to proceed with deep
cleaning or replacement (please contact your local dealer to purchase special ONE COVER ALL
brush strips for replacement ).
1.
2.
3.
4.
5.
Fig.1
Fig.4 Fig.5
Fig.2 Fig.3
B
rush
t
ube
retainer