SDS

ManualsBrandsITP ManualsPipe InsulationTundra® 5/8" ID x 3/8" Wall Self-Sealing Foam 90-Degree Elbow

SAFETY DATA SHEET

(Owned and Operated by Armacell Canada Inc.)

PHONE NO.: 1-905-846-3666

FAX NO.: 1-905-846-0363

EMERGENCY PHONE NO.: 1-800-387-3847

SWALLOWING SKIN ABSORBTION INHALATION SKIN CONTACT EYE CONTACT

EFFECTS OF A SINGLE (ACUTE) OVEREXPOSURE BY:

BRAMPTON, ONTARIO , L7A 1A4

INGREDIENTS

SECTION 2 : HAZARD(S) IDENTIFICATION

- POLYETHYLENE EXTRUDED FOAM PRODUCTS ARE CLASSIFIED BY OSHA AS "NON HAZARDOUS".

- PE FOAM PRODUCTS ARE MADE FROM POLYETHYLENE RESIN , ADDITIVES AND ISOBUTANE .(MORE DETAILS IN SEC.3.)

CAS NO.

WEIGHT %

EXPOSURE LIMITS

ACGIH - TLV*

POLYETHYLENE

9002-88-4

75% -100%

ISOBUTANE

75-28-5

800 PPM TWA

CARBON BLACK

1333-86-4

0% - 5%

3.5 mg/m

ANTIMONY COMPOUND

1309-64-4

0% - 5%

0.5 mg /m

NOT LIKELY.

SWALLOWING:

CHOKING - MECHANICAL BLOCKAGE

SKIN ABSORBTION:

PRODUCT

IDENTIFIER:

ITP P.E. FOAM PROFILES AND EXTRUSIONS

(WITH BLACK PIGMENT & F/R)

CHEMICAL

RECOMMENDED

USE

PACKAGING, CUSHIONING, SOUND DAMPENING,

INSULATION,SEALING, FLOATATION etc.

SECTION 2 : HAZARD(S) IDENTIFICATION

- ISOBUTANE, A FLAMABLE HYDROCARBON IS USED AS BLOWING AGENT.SMALL TRACES OF THIS GAS MAY BE

PRESENT IN THE PRODUCT. THIS GAS MAY ACCUMULATE AT HAZARDOUS CONCENTRATIONS ABOVE THE LOWER

FLAMMABLE LIMITS (LFL) IF LARGE QUANTITIES OF THIS PRODUCT ARE STORED IN UNVENTILATED AREAS.

IDENTITY:

POLYETHYLENE

NONE

ROUTES OF

EXPOSURE:

153 VAN KIRK DRIVE

MANUFACTURER NAME & ADDRESS:

INDUSTRIAL THERMO POLYMERS

SECTION 3 : COMPOSITION / INFORMATION ON INGREDIENTS

CONSULT PHYSICIAN

INHALATION:

RESTRICTION OF

USE

SECTION I : IDENTIFICATION

* Applicable provincial TLV's may differ

* Specific chemical names and percentage in the mix has been withheld to protect trade secret.

SECTION 4 : FIRST AID MEASURES

SWALLOWING:

6. CHEMICAL/GASEOUS HAZARDS LIKE CO, CO2 AND CARBON MAY BE PRODUCED FROM THE SMOLDERING SUBSTANCES AND FIRE.

SKIN CONTACT:

WASH WITH SOAP AND WATER

EYE CONTACT:

MOVE TO FRESH AIR. SEEK MEDICAL ATTENTION IF

BREATHING PROBLEMS PERSISTS.

FLUSH EYES WITH CLEAN LUKEWARM WATER. CONSULT

PHYSICIAN.

SECTION 5 : FIRE FIGHTING MEASURES

1. PE FOAM IS COMBUSTIBLE AND SHOULD NOT BE EXPOSED TO SPARKS OR OPEN FLAME. RESULTS IN CLASS 'A' FIRE.

2. FIRE TO BE EXTINGUISHED BY USING WATER FOG OR FINE SPRAY. SOAK THE PRODUCT WITH WATER TO COOL AND SMOTHER.

INHALATION:

FOAM DUST MAY CAUSE RRITATION TO NOSE ,THROAT OR LUNGS.

SKIN CONTACT:

NON IRRITATING TO SKIN CONTACT

EYE CONTACT:

EYE INJURY OR FOAM DUST MAY CAUSE IRRITATION TO EYES

OTHER EFFECTS

NOT KNOWN

3. FIRE WILL CAUSE DENSE SMOKE. USE SELF-CONTAINED BREATHING APPRATUS AND FULL PROTECTIVE CLOTHING.

4. FIRE WILL RESULT IN INTENSE HEAT AND SMOLDERING. EXTINGUISHMENT IS BY COOLING WITH WATER.

5. OTHER FIRE EXTINGUISHERS (DRY CHEMICAL, FOAM OR CO2 EXTINGUISHERS) MAY BE USED FOR EXTINGUISHMENT.



Dt Printed:4/20/2015

SAFETY DATA SHEET (PE FOAM -BLACK WITH FR) - Apr 2015 Page 1 of 2

Summary of content (2 pages)

PAGE 1
SAFETY DATA SHEET SECTION I : IDENTIFICATION PRODUCT IDENTIFIER: CHEMICAL IDENTITY: RECOMMENDED USE RESTRICTION OF USE ITP P.E. FOAM PROFILES AND EXTRUSIONS (WITH BLACK PIGMENT & F/R) MANUFACTURER NAME & ADDRESS: INDUSTRIAL THERMO POLYMERS (Owned and Operated by Armacell Canada Inc.) POLYETHYLENE PACKAGING, CUSHIONING, SOUND DAMPENING, INSULATION,SEALING, FLOATATION etc. NONE 153 VAN KIRK DRIVE BRAMPTON, ONTARIO , L7A 1A4 PHONE NO.: 1-905-846-3666 FAX NO.: 1-905-846-0363 EMERGENCY PHONE NO.
PAGE 2
SAFETY DATA SHEET SECTION 6: ACCIDENTAL RELEASE MEASURES PE FOAM IS COMBUSTIBLE. SHOULD NOT BE EXPOSED TO SPARKS OR OPEN FLAME. RESULTS IN CLASS 'A' FIRE. SECTION 7: HANDLING AND STORAGE - PE FOAM IS COMBUSTIBLE AND SHOULD NOT BE EXPOSED TO SPARKS OR OPEN FLAME. WHEN BURNS,WILL RELEASE TOXIC GASES LIKE CO . -WHEN FABRICATING OR CUTTING , THIS PRODUCT MAY RELEASE TRAPPED ISOBUTANE FROM THE FOAM CELLS. ADEQUATE VENTILATION IS A MUST. - PE FOAM SHOULD BE STORED IN COOL,DRY AND WELL VENTILATED LOCATIONS.