User's Manual

Installing the 100G ERT Module
2. Remove and keep the cover screws.
3. Remove the index cover from the meter.
4. Check the screws for length and corrosion. If they are 5/8 inches long and not
corroded, you can use them to attach the 100G ERT Module to the meter.
If the screws are not the correct length, or are corroded, dispose of them properly.
Replace them with the screws listed in
Replacement Screws on page 42.
5. Use the index cover just removed as a temporary storage location for screws.
NOTE Dispose of the index cover properly when finished with the installation
procedure. Do not leave it on customer premises.
6. Loosen the index mounting screws one-half turn.
7. Slide the index up off its mounting screws and remove it from the meter. Set the index
where it won't get damaged or dirty.
Natural Gas Solutions 100G Installation Guide 43