User's Manual

Installing the 100G ERT Module
If the index has mounting screw holes, perform steps 4 and 5 below, and then skip
steps 6 and 7.
4. If the index has mounting screw
holes, place an index mounting screw (1) in the right-
hand mounting screw hole (2). Use one 8 - 32 3/16-inch screw for this step (you can
use an original mounting screw if it was the correct size and not corroded; otherwise,
use the correct size replacement screw).
1
2
5. Attach the screw to the ERT backplate's right-hand index mounting post just far
enough to hold the screw and end of the index in place.
6. If the index has mounting screw
slots, screw an index mounting screw (1) one to two
turns into the ERT backplate's right-hand index mounting post (2). Use one 8 - 32 x
3/16-inch screw for this step (you can use an original mounting screw if it was the
correct size and not corroded; otherwise, use the correct size replacement screw).
Natural Gas Solutions 100G Installation Guide 19