User's Manual

Installing the 100G ERT Module
5. Remove the mounting plate screws and separate the mounting plate from the meter.
Set the mounting plate aside where it will not get damaged. You will use it later in the
installation.
Program the ERT
The ERT must be programmed using the FC200SR with EndPoint-Link software. See the
Endpoint-Link ERT Programming Guide (TDC-0411) for more information.
IMPORTANT You must perform the following programming procedure for
the ERT module to function properly.
When programming the ERT module, you must take note of the drive rate shown on the
index of the meter. Program the meter based on the drive rate shown on the index.
To program the ERT module
1. Using the FC200SR, program the reading of the index that was on the meter into the
ERT module assembly.
Natural Gas Solutions 100G Installation Guide 61