User's Manual

Itron Meter Installation
5. Rotate the ERT module down until the module mounting hole is approximately 1/4-inch below the meter
hole.
6. Rotate the ERT module up to align the left mounting holes. Raising and lowering the ERT module on the
meter drive post facilitates the proper positioning and engagement of ERT module wriggler with the meter
drive post.
7. Insert the left mounting screw and tighten a few turns.
8. Tighten the right and left ERT-to-meter mounting screws in an alternating pattern. Tighten each mounting
screw evenly.
Important Meter manufacturers: torque the mounting screws 15 to 20 inch-pounds.
TDC-0823-014 100G Series Gas ERT Module Installation Guide, Direct Mount 37
Proprietary and Confidential