User's Manual

This chapter provides the instructions to install the ERT module on an Elster American Meter.

Removing the Meter Index

Begin the module installation by removing the index cover and index from the meter.

To remove the index from the meter

1. Remove the four index cover screws and the index cover from the Elster American meter. Alternate screw

removal following the numbered pattern in the photo.

2. Examine the mounting screws. If they are 5/8-inch long and not corroded, keep them to install the 100G

assembly to the meter. If the screws are not the correct length or if the screws are corroded, discard.

Note You may use the removed index cover as a temporary storage container for screws. Properly

dispose all unused screws, old index covers, gaskets, tamper seals, and other leftover materials.

C HAPTER 2

lster American Meter Installation

TDC-0823-014 100G Series Gas ERT Module Installation Guide, Direct Mount 17

Proprietary and Confidential