User's Manual

Itron Meter Installation
3. Remove the old gasket, gasket residue, and dirt from the meter (if applicable). The meter face must be free
of gasket residue or dirt before you install the 100G.
Note Properly dispose all unused screws, old index covers, gaskets, tamper seals, and other leftover
materials. Do not leave materials on customer premises.
Assembling the Gas ERT Module and Index
Continue ERT module installation by assembling the ERT module and index.
To assemble the 100G series gas ERT module and index
1. Separate the ERT module housing from the cover by pulling the cover straight out from the housing. Set
the module cover aside where it will not be damaged or fill with rain, dirt or snow. The cover is used later
in this installation procedure.
2. Screw the index mounting screws into the index mounting posts loosely (one to two turns). Do not tighten
the screws.
TDC-0823-014 100G Series Gas ERT Module Installation Guide, Direct Mount 43
Proprietary and Confidential