User's Manual Part 2
Chapter 3 Sensus/Rockwell Meter Installation
28 100G Datalogging Installation Guide - Direct Mount
Install the remaining three mounting screws and tighten in the pattern shown.
• Insert lower left mounting screw and tighten to snug position.
• Tighten upper right mounting screw to snug position.
• Insert upper left mounting screw and tighten to snug position.
• Insert lower right mounting screw and tighten to snug position.
Each mounting screw should be tightened evenly.
Important Meter manufacturers should torque the mounting screws 15 to 20
inch-pounds.
2. Place a new tamper seal over the two screws with tamper seal cups. Press the new
tamper seals into place using the 11/32-inch nut driver (or similar blunt tool).
3. Complete any necessary paperwork and properly dispose excess installation materials
and scrap from the customer premises.