User's Manual Part 3

Chapter 7 Sensus/Rockwell Commercial Meter Installation
74 100G Datalogging Installation Guide - Direct Mount
2. Remove the index screws from the meter. Set the index cover aside where it will not
be damaged or fill with dirt, rain or snow. You will re-install the index later in this
procedure.
Note Properly dispose all unused screws, old index covers, gaskets, tamper seals,
and other leftover materials. Do not leave materials on customer premises.
Programming the 100G Datalogging Gas Endpoint
The 100G Datalogging Commercial Endpoint must be programmed with the
FC200SR handheld computer loaded with EndPoint-Link
®
or Point-Link Pro
®
software version 5.3 or later. See the Endpoint-Link v5.3 (or later) Endpoint
Programming Guide (TDC-0744) for more complete programming information.
Caution The 100G Datalogging Commercial Sensus/Rockwell Endpoint must be
programmed before use. Follow the steps in this section to properly program the
endpoint.