User's Manual Part 3

Chapter 6 Elster American and Itron Actaris Commercial Meter Installation
60 100G Datalogging Installation Guide - Direct Mount
3. Remove the gasket from the index cover mounting plate (if applicable). Set it aside
where it will not be damaged. Remove the tamper seals from the mounting plate.
Remove the mounting plate screws and separate the mounting plate from the meter.
Place the mounting plate where it will not be damaged. You will use it later in this
installation.
Programming the 100G Datalogging Commercial Gas
Endpoint
The 100G Datalogging Gas Endpoint must be programmed with the FC200SR
handheld computer loaded with EndPoint-Link
®
or Point-Link Pro
®
software version
5.3 or later. See the Endpoint-Link v5.3 (or later) Endpoint Programming Guide
(TDC-0744) for more complete programming information.
Caution The 100G Datalogging Commercial Endpoint must be programmed
before use. Follow the steps in this section to properly program the endpoint.