User's Manual

DATTUS Meter Installation
TDC-0824-003 100G Datalogging FN ERT Module Installation Guide - Remote Mount 72
Proprietary and Confidential
To program the 100G Datalogging FN remote ERT module
1. Program the meter drive rate into the 100G Datalogging FN remote ERT module using a handheld
computer or Belt Clip Radio and laptop computer. For all programming and Check Endpoint operations
using a handheld computer, hold the handheld as Verify you have the correct programming mode (Fixed
Network Mode, Mobile High Power Mode, Mobile/Handheld Mode, or Hard to Read Mobile/Handheld
Mode) for your application. Programming parameters are based on the configuration file loaded into the
programming device. During programming, the 100G Datalogging FN remote ERT module is set to the
nearest 100 cubic feet; the last two digits (tens and units) are programmed as zeros (0). After
programming is complete, the ERT module assembly will read to the nearest cubic foot.
2. Read or Check the 100G Datalogging FN remote ERT module using the handheld computer or Belt Clip
Radio.
If the read result is higher than the number programmed in step 1, the 100G Datalogging FN remote
ERT module is counting correctly.
If the read result is not higher than the number programmed in step 1, replace the 100G Datalogging
FN remote ERT module.