User's Manual

Chapter 2 Installing the 100G Remote ERT Module
Adapter Plate Mounting Positions
The installation procedure in this section shows how to mount the adapter plate on vertical
pipes. The following pictures show how to mounting the adapter plate on pipes that are
either horizontal or at 45 degree angles. Regardless of which direction the pipe goes, the
adapter plate mounting lug must always be at the top.
If the pipe is at a 45 degrees angle up to the right, install the adapter plate as shown.
Mounting lug
Screws
If the pipe is at a 45 degrees angle up to the left, install the adapter plate as shown.
Mounting lug
Screws
If the pipe is horizontal, install the adapter plate as shown.
12 Natural Gas Solutions 100G Installation Guide for Mercury Electronic Volume Correctors
DRAFT