User's Manual

Chapter 2 Installing the 100G Remote ERT Module
To program the ERT module
1. Using the FC200SR, program the reading of the index that was on the meter into the
ERT module assembly.
• For initial programming, hold the FC200SR approximately 1 foot away from
the 100G.
• For reprogramming (30 days or more past initial programming), hold the
FC200SR approximately 4 to 5 feet away from the 100G.
Be sure to program the 100G to the correct mode for the reading technology that will
be used (for example, Fixed Network Mode, Mobile/Handheld Mode, or Hard to Read
Mobile/Handheld Mode). In Endpoint-Link Pro v5.0, you will have access to the one
mode that was defined by your system administrator.
2. Read the ERT module assembly using the FC200SR. Consult the
EndPoint-Link ERT
Programming Guide
(TDC-0411) or other applicable instructions for details on how to
read an ERT.
• If this reading is higher than the one you programmed in step 1 above, the ERT
module assembly is counting correctly.
• If the ERT module assembly reading is
not higher than what was programmed
in step 1, replace the ERT module with a new one.
To connect the ERT cable to the corrector
1. Insert the ERT cable into the compression connector.
16 Natural Gas Solutions 100G Installation Guide for Mercury Electronic Volume Correctors
DRAFT