User's Manual
Table Of Contents
- Contents
- Before You Begin
- About the 100T-HON Honeywell Telemetry Module
- Mounting the 100T-HON Telemetry Module
- Connecting and Configuring the Module and Instrument
- Installation Overview
- Programming the Mercury Instrument Parameters
- Honeywell Instrument Call-In Configuration
- Connecting the 100T-HON Telemetry Module to the Instrument
- Programming the 100T-HON Telemetry Module
Connecting and Configuring the Module and Instrument
TDC
-1346-000 100T-HON Honeywell Telemetry Module Installation Guide 21
Proprietary and Confidential
4. Connect the 100T-HON telemetry module to the instrument RS232 terminal block connections.
5. (Optional) To connect the 100T-HON telemetry module for mechanical uncorrected volume pulser data,
connect the 100T-HON telemetry module to the three-wire screw terminal connector on the mechanical
pulser board. Connect only to the NO and COM.
6. After the 100T-HON telemetry module is wired to the instrument, see Mounting the 100T-HON
Telemetry Module for module mounting instructions.