User's Manual

Installing the 100W-R and 100WP-R Endpoints
TDC-0951-001 100W-R and 100WP-R Datalogging Water Endpoint Installation Guide 27
Proprietary and Confidential
2. Connect the endpoint wires to the register using gel-cap connectors (see Using Gel-cap Connectors on
page 33) following the 100W-R encoder to the Badger ADE register wire connections, (see Connecting
100W-R to a Remote Meter Register on page 7). After connecting the wires, carefully tuck the connectors
into the endpoint housing.
3. To wire the 100WP-R to the RTR 2-wire register, connect the endpoint wires to the 2-wire register using
gel-cap connectors (see Using Gel-cap Connectors on page 33). After connecting the wires, carefully tuck
the connectors into the endpoint housing.
4. To connect the 100WP-R pulser to the RTR 2-wire register, see Connecting the 100WP-R to a Remote
Meter Register on page 8. The endpoint's yellow wire is not used. Tuck the yellow wire back into the
endpoint housing with the gel-cap connectors.