User's Manual

TDC-0951-001 100W-R and 100WP-R Datalogging Water Endpoint Installation Guide 33
Proprietary and Confidential
This section describes connecting the 100W-R and 100WP-R endpoints to the water meter register using gel
cap connectors.
Required Materials
E-9R 3M® gel cap crimping tool
Gel cap connectors
1. Push two wires as far as possible into the connector.
Caution Do not strip insulation from the ends of the wires before inserting them into the connector.
2. Carefully place the connector and wires into the jaws of the crimping tool. Make sure the wires remain
fully inserted in the gel-cap connector.
A P P E N D I X A
Using Gel-cap Connectors